C&K systems System 238 Instrukcja Instalacji Pobierz pdf (Strona 7)

SYSTEM 238 Installation Manual

PROGRAMMING the ALPHA KEYPAD

Keypad Message Programming

The Alpha keypad programming template is used to allow the in-

staller to program messages and zone descriptions into the Alpha

keypads. The template shown below should be used when pro-

gramming the keypad.

To activate the keypad programming mode, enter the [Installer's

Code] [*] [0] [1] [#]. Information may be entered into the key-

pad in the form of letters (upper and lower case), numbers (0 -

9), and 22 special symbols. All characters are displayed in the

order listed above, i.e. upper and lower case letters, numbers,

and special symbols. The [Space] character precedes the letter

To enter a Message or Label, use the [2] key to scroll through the

characters until you reach the desired character. If you scroll past

the desired character, the [8] key may be used to scroll back-

wards.

When the desired character is displayed, press the [6] key to move

the cursor to the next character position. The [4] key moves the

cursor to the left. When all characters have been entered, press

the [#] key to write the message and move to the next message

position. Use the [0] key to move backward through the messages.

Ensure the Alpha keypad is wired to the SYSTEM 238 and power is

applied to the control panel. You can only access the programming

mode when the control panel is disarmed.

NOTE: Programming the Keypad is not the same as Keypad

Programming.

123

789

ALPHAII Programming Template

ALPHAPLUS Programming Template

12 3

78 9

NOTE: If you do not press any key for 5 minutes, the

keypad will automatically exit the programming

mode.

To Exit Keypad Programming

When you have finished programming, press [*] [#]. The keypad

will also exit the programming mode if you do not press any

key within a five minute period.

The Alpha Keypad

You can program the Alpha keypads for special messages, each

of the 8 zone labels, and the keypad address. Zone Labels

display during the walk-test and when the [#] key is pressed

during alarm memory or faults. The programmable Service

Message is displayed during AC failure, fuse failure, communica-

tion failure, or low battery. The Dealer Message displays when the

system is disarmed. The keypad address is initially displayed only

during system start up (see page 5, Keypad Addressing).

These messages can be programmed directly from the Alpha

keypad or remotely using the Commander II/Monitor II software

package. For more detailed information about remote program-

ming, refer to the Commander II/Monitor II Operating Manual.

The Scrolling order of the Alpha Plus messages is:

 SERVICE MESSAGE

 DEALER MESSAGE

 SOFT ZONE IDENTIFIER (C)

 HARDWIRED LOOP IDENTIFIERS

 KEYPAD ADDRESS

Both the Alpha and the Alpha Plus use the same procedure to

program messages.

PROGRAMMING CONVERSIONS

Hexadecimal Value

Key Strokes

The last two Command Locations are CL 37 and CL A0. Pressing

the [#] key at these locations will advance you to CL 38 or CL A1,

respectively. Locations CL 38 and CL A1 are not used in the

SYSTEM 238. If you accidentally enter either of these locations,

press [*] [#] to exit programming, or enter the Command

Location number, followed by the [#] key, for the location you wish

to program.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

C&K systems System 238 Instrukcja Instalacji Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa C&K systems System 238